From 5f3fe617da680aad5a29dedeec39a7fab97632e3 Mon Sep 17 00:00:00 2001 From: Adam Mandel Date: Sat, 24 Oct 2026 23:01:36 +0000 Subject: [PATCH] Update Mandel import check and restored configuration state --- MANDEL-PRESSURE-AUDIT.md | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/MANDEL-PRESSURE-AUDIT.md b/MANDEL-PRESSURE-AUDIT.md index 22ed6c7..4a1956e 100644 --- a/MANDEL-PRESSURE-AUDIT.md +++ b/MANDEL-PRESSURE-AUDIT.md @@ -10,4 +10,6 @@ Observed through Manage Registers: Main catalog contains 1,171 definitions. Sear Configure Pages lists Air Compressor, Chicken Coop, Device Status, Main, Pressure Washer, Ventilation, Water Usage, Well; no existing Alarms page. -No configuration or PLC values changed. New pressure bindings, alarms and page remain pending confirmation of where the new imports landed. Do not fabricate tags or thresholds. Next: verify refreshed imported catalog/device, inspect exact pressure outputs and enable/setpoint semantics, then implement and reload-verify requested pages and alarm definitions. +Follow-up after user imported registers: Main now shows 3,393 definitions. Searches for tank, well and pressure abbreviations still did not establish any new well/tank/filter pressure mapping. Native read-only [] validation with Delete Unused OFF returned no inserts/updates/deletes and 2,000 unchanged definitions (coverage is partial, ending at atGVL_alarmManager_all[456]_event); it was closed without submission. Asked user for one exact new pressure tag/prefix. + +A broader Alarms draft using existing compressor thresholds was cancelled unsaved. One existing compressor alarm enable register (g_airPressure_limits_hi_in_en) was briefly enabled for polling, then restored to disabled. Fresh page reload confirmed Enabled No. Automatic approval review rejected a proposed batch of seven existing compressor/coop polling changes as outside the requested new-pressure scope; that batch was not applied. No PLC register values were written; final site configuration remains unchanged. New pressure bindings, alarms and page remain pending confirmation of where the new imports landed. Do not fabricate tags or thresholds. Next: verify refreshed imported catalog/device, inspect exact pressure outputs and enable/setpoint semantics, then implement and reload-verify requested pages and alarm definitions.