16 lines
2.4 KiB
Markdown
16 lines
2.4 KiB
Markdown
# Mandel pressure import check — October 24, 2026
|
|
|
|
Target: https://dev.atomhmi.com/site_mandel/.
|
|
|
|
User requests well, tank (primary), and filter differential pressure (well minus tank), associated new alarms/setpoints, and an Alarms page with enable settings.
|
|
|
|
Read repository AGENTS.md, PROJECT.md, HANDOFF.md, MANDEL-BUILD.md and MANDEL-SETTINGS.md, and current cloud knowledge base/settings guide before edits.
|
|
|
|
Observed through Manage Registers: Main catalog contains 1,171 definitions. Search `tank` returns no matching records. Pressure searches inspected so far show existing air compressor and pressure washer families; no verified well/tank/filter differential pressure mapping was established. The `well` search contains 482 matches, including existing well flow and sequence definitions. Global has 13 entries and no well matches. Global `stale_data_codesys` displayed 1; Main register values and overview readouts were blank. This does not establish the communication failure cause.
|
|
|
|
Configure Pages lists Air Compressor, Chicken Coop, Device Status, Main, Pressure Washer, Ventilation, Water Usage, Well; no existing Alarms page.
|
|
|
|
Follow-up after user imported registers: Main now shows 3,393 definitions. Searches for tank, well and pressure abbreviations still did not establish any new well/tank/filter pressure mapping. Native read-only [] validation with Delete Unused OFF returned no inserts/updates/deletes and 2,000 unchanged definitions (coverage is partial, ending at atGVL_alarmManager_all[456]_event); it was closed without submission. Asked user for one exact new pressure tag/prefix.
|
|
|
|
A broader Alarms draft using existing compressor thresholds was cancelled unsaved. One existing compressor alarm enable register (g_airPressure_limits_hi_in_en) was briefly enabled for polling, then restored to disabled. Fresh page reload confirmed Enabled No. Automatic approval review rejected a proposed batch of seven existing compressor/coop polling changes as outside the requested new-pressure scope; that batch was not applied. No PLC register values were written; final site configuration remains unchanged. New pressure bindings, alarms and page remain pending confirmation of where the new imports landed. Do not fabricate tags or thresholds. Next: verify refreshed imported catalog/device, inspect exact pressure outputs and enable/setpoint semantics, then implement and reload-verify requested pages and alarm definitions.
|